Know The Best Techniques To Clean Your Favorite Glass Beaker Bong

For all bong lovers, one of the most painful experiences is cleaning a dirty bong. If you're currently ripping off a depleting, dirty pipe or glass bong, you know the agony and frustration. It can ruin your entire experience of inhaling your prized strains. Cleaning is another tedious job, which may make you shiver or flinch. With most bongs that you have now, you can find several nooks and crannies. The opulence of angles and curvatures make it really intimidating to clean your Glass Beaker Bong with that threadbare honeycomb stick or perc that leads to 12 tree objects. However, there are ways to clean your dang glass.

A quick formula

To clean your Glass Beaker Bong without much toil, add some coarse salt. Next, add isopropyl alcohol. Shake the mixture vigorously. You are almost done. You need to remember that you must use at least 90% isopropyl or rubbing alcohol. Mix it with coarse salt for breaking down the gunk and tar in your bong. It will leave the base clean and nice. You need a few supplies for cleaning a dirty bong. If the job is tougher and isopropyl cannot do it, you can use nail polish remover. You can also use Epsom salt in place of coarse sea salt, if need be. The other supplies are hand towels, paper towels, Ziploc baggies, and a bucket or a bathtub.

A stepwise cleaning

Disassemble your bong, taking apart its pieces. Rinse each one of them with hot water. It will destroy the gunk. You can also reach out to any of the residuals or hanging fruits at the base of your Glass Beaker Bong. In the second step, place your bowl and downstem into Ziploc baggies. Lace it with alcohol and give it some time for soaking in the solution. This is a very crucial step.

The third step

Pour a mixture of salt and rubbing alcohol in your Glass Beaker Bong. Make sure you pour sufficient mixture to specific areas that are full but are yet to overflow. The alcohol mustn't spill out of the bong's opening or touch the point of its downstem. As far as the salt goes, add only that amount to the mixture till it does not dissolve in the isopropyl. If you find that the salt is dissolving, you need to abort the plan as it won't do its job. The salt will not act as an abrasive for breaking down and eliminating the residue in your beaker bong.

The next steps

Tightly seal the hole at the bottom with a paper towel. You can then plug up the bong's opening at the top with a hand towel. Use your thumb for creating a tight seal on the base. Use your other hand's thumb to cover the top opening. The next step is to shake it as vigorously as you can. In the sixth step, pour out the dirty alcohol solution. It becomes nasty after a while. Rinse the glass bong with hot water. Repeat the step for 3-5 times. It depends on how dirty your beaker bong is. For more information visit here: Tank Glass